Cisco SPA8800 Informations techniques télécharger pdf (Page 119)

Installing the UC 320W and Phones

Connecting a PC to a Phone (Optional)

Cisco Unified Communications UC320W Administration Guide 119

Connecting a PC to a Phone (Optional)

PC ports are not available on Cisco SPA300 Series phones.

A PC cannot be connected to Cisco SPA525 models that are connected to the

wireless network.

STEP 1 To provide network access to a PC, connect one end of an additional Ethernet

cable (not provided) to the PC port on the back of the phone body. See the

illustrations in the Phone Connections, page 107.

STEP 2 Connect the other end of the Ethernet cable to the network port on the PC.

After receiving power and network connectivity, the phone executes a boot-up

sequence. During this sequence, phones with screens display the Cisco logo and

then “Initializing Network.” All of the lights on the phone will flash.

After your phone is successfully connected to the network, it receives a basic

configuration. On all models except Cisco SPA501G, the time, date, extension

number, and softkeys appear on the display screen. On Cisco SPA501G, which

has no display screen, you should hear a dial tone when picking up the handset or

pressing the speakerphone button.

If the phone does not start, confirm your installation and connections. If these are

correct, try unplugging the phone and plugging it back in again.

Upgrading the Phone Firmware

Use the 320W Configuration Utility to upgrade the firmware for all components of

the Unified Communications system.

Connecting Attendant Consoles

For extra line buttons, you can connect up to two Cisco SPA500S Attendant

Consoles to a Cisco SPA500 Series IP phone. Before you begin, you need the

following items:

• Cisco SPA500S Attendant Console

1 2 ... 114 115 116 117 118 119 120 121 122 123 124

Pas de commentaire

Cisco SPA8800 Informations techniques Page 119