Cisco 15310-MA Guide de dépannage télécharger pdf (Page 340)

4-32

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

WID-3384 You are about to force the use of Secure Mode for this chassis.

You will not be able to undo this operation.

Is it OK to continue?

Refer to the warning message text.

EID-3385 {0}. Delete the circuits and try again. Refer to the error message text.

EID-3386 The transponder mode could not be provisioned:

{0}

The specified transponder mode cannot be

provisioned.

EID-3387 You must change port(s) {0} to an out-of-service state before

changing card parameters. Click “Reset” to revert the changes.

All the card ports should be changed to

out-of-service before changing the

parameters.

EID-3388 The card mode cannot be changed because the card has circuits. Refer to the error message text.

EID-3389 An error occurred while changing the card mode. Refer to the error message text.

EID-3390 The port is in use. Refer to the error message text.

EID-3391 The port rate cannot be changed because the port has been

deleted.

You cannot change the port rate of a card

that has been deleted.

WID-3392 The timing reference(s) could not be assigned because with

external timing, only a single protected, or two unprotected

timing references per BITS Out can be selected.

Please use the “Reset” button and verify the settings.

Refer to the warning message text.

WID-3393 The timing reference(s) could not be assigned because with line

or mixed timing, only a single unprotected timing reference per

BITS Out can be selected.

Please use the “Reset” button and verify the settings.

Refer to the warning message text.

EID-3394 An error occurred while refreshing the power monitoring

values.

Refer to the error message text.

EID-3395 The configuration is invalid.

{0}

CTC encountered an error in IP address, net

mask length, or default router, or a

restricted IIOP port was selected.

EID-3396 The configuration is invalid. The standby controller card is not

a TCC2P card.

The standby controller card should be a

TCC2P card.

EID-3397 The file {0} is the wrong version. The specified file is of wrong version.

EID-3398 The PPM cannot be deleted. Refer to the error message text.

EID-3399 The PPM cannot be deleted because it has port(s) in use. Remove the ports connected to the

Pluggable Port Module before it can be

deleted.

EID-3400 Unable to switch. A force to the primary facility is not allowed. Refer to the error message text.

EID-3401 {0} cannot be provisioned for the port while {1} is enabled. The relationship between parameters {0}

and {1} are such that enabling either one,

prevents the provisioning of the other.

EID-3402 The switch request could not be completed.

The {0} card is not present or is not responding.

Try again after ensuring that the {0} card is present and is not

resetting.

Refer to the error message text.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 335 336 337 338 339 340 341 342 343 344 345 ... 379 380

Commentaires sur ces manuels

Pas de commentaire

Cisco 15310-MA Guide de dépannage Page 340

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cisco 15310-MA