search

Cisco GoQAM Informations techniques Page 35

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 308
  • Table des matières
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 34
CLI Login and Logout
4025561 Rev
A
11
To Log Out
To log out of the CLI and exit the session, type logout, and then press Enter.
Note: The CLI recognizes the logout command at any command prompt, regardless
of the current command mode.
Important:
For Telnet operation, the computer you are using must have a network
connection through which it can reach the ICIM2 using its IP address.
No more than four Telnet sessions are allowed at one time.
If IPsec is enabled on the ICIM2, it must also be enabled on the remote CLI user's
computer.
CAUTION:
Always use the Logout command to close a serial port or Telnet CLI session.
Closing a serial port session without issuing the Logout command leaves the
session open for a possible future connection. This may allow unauthorized
access by a new user if the previous user had a higher authorization privilege
level.
Vue de la page 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 307 308

Commentaires sur ces manuels

Pas de commentaire
  • Arrow Pneumatics U.S. Boiler Company ELF Avalon Acoustics Hestan
  • Adcom Récepteurs AV Liebert Thermomètres corporels numériques Rinnai Poêle à pellets RotoZip Outils électriques Garland Cuisiniers
  • HP EliteDisplay S14 14-inch Portable Display Samsung GT-S5310B Philips MCM700/12 Pioneer CDJ-500II Acer B246WL
  • Philips 52PFL7762D Manuel de l'utilisateur Partner T280 Manuel de l'utilisateur Welch-allyn PROPAQ CS Manuel de l'utilisateur Samsung UA32C5000 Manuel de l'utilisateur Asus PA248QR Guide de l'utilisateur