Cisco GoQAM Informations techniques télécharger pdf (Page 34)

Cha

2 CLI Overview

10 4025561

Rev

CLI Login and Logout

To use the CLI, you must first establish communication with a chassis in one of two

ways:

 Use a serial connection (e.g., HyperTerminal) as described in the Prisma II

Enhanced Management System Guide, System Release 2.04, part number 4025559.

 Use your element management system (see your network administrator for

assistance).

Once communication is established, the control console or PC displays the following

message from the ICIM2:

Scientific-Atlanta Intelligent Communications Interface Module (ICIM)

---------------------

W A R N I N G

---------------------

Unauthorized or improper use of this system may result in

administrative disciplinary action and civil or criminal penalties.

By continuing to use this system you indicate your awareness of and

consent to these terms and conditions of use. LOG OFF IMMEDIATELY

if you do not agree to the conditions stated in this warning.

Note: When communicating via serial connection, some terminal programs may

send unexpected characters to the ICIM2 on initial connection. If this occurs and the

user presses the Enter key to access the login prompt, the ICIM2 may interpret the

unexpected characters as an invalid user name. This leads to a trap and an entry in

the event log indicating a failed login.

To Log In

Complete the following steps to log into the CLI.

1 At the login prompt, type your assigned user name (or if none is assigned, type

Administrat0r), and then press Enter. The user name is case-sensitive.

2 At the password prompt, type your assigned password (or if none is assigned,

type AdminPassw0rd), and then press Enter. The password is case-sensitive.

An acknowledgement similar to the following appears:

User Admininstrat0r logged in successfully on 09/05/06 at 8:09:18

Previous successful login was on 09/01/06 at 15:56:28

There were no failed attempts to login with this user id previously

CLI>

You can now use CLI commands to interact with the ICIM2.

Note: For security reasons, it is recommended that the default user be changed

immediately. For additional information, see the User Management chapter of the

Prisma II Enhanced Management System Guide, System Release 2.04, part number

4025559.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 307 308

Pas de commentaire

Cisco GoQAM Informations techniques Page 34