Cisco WUMC710 Manuel d'utilisateur télécharger pdf (Page 71)

Product Overview

Linksys WUMC710

Thank you for choosing the Linksys Wireless-AC Universal Media Connector.

The media connector can connect any wired Ethernet device to your wireless

network. The media connector is based on Wireless-AC, so it is compatible

with Wireless-N (5 GHz) and Wireless-A routers or access points. For first-

time installation, follow the steps in the Quick Installation Guide. To configure

advanced settings, use the convenient browser-based utility.”

LED panel

Wireless (Blue) The Wireless LED lights up when there

is a wireless connection. The LED flashes when the media

connector is actively sending or receiving data over the

wireless network.

Wi-Fi Protected Setup Button If your router supports Wi-

Fi Protected Setup and uses WPA or WPA2 security, then

you can use Wi-Fi Protected Setup to automatically connect

the media connector. To use Wi-Fi Protected Setup, refer to

“Wireless > Basic Wireless Settings” on page 7.

Wi-Fi Protected Setup LED (Blue/Amber) The LED flashes

blue for two minutes during Wi-Fi Protected Setup. It

lights up blue when wireless security is enabled. If there

is an error during the Wi-Fi Protected Setup process, then

the LED lights up amber. Make sure the network router

supports Wi-Fi Protected Setup. Wait until the LED is off,

and then try again.

Ethernet (Blue) The Ethernet LED lights up when there

is a wired connection. The LED flashes when the media

connector is actively sending or receiving data over the

Ethernet port(s).

Power (Blue) The Power LED lights up when the media

connector is powered on.

Product Overview

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 288 289

Pas de commentaire

Cisco WUMC710 Manuel d'utilisateur Page 71