Cisco WUMC710 Manuel d'utilisateur télécharger pdf (Page 76)

Advanced Configuration

Linksys WUMC710

Setup > Basic Setup

The first screen that appears is the Basic Setup screen. Use this screen to change

the browser-based utility’s language, or to change the media connector’s wired

Ethernet network settings.

Language

Language This is used to set the language displayed by the browser-based

utility. Select the desired language from the drop-down menu.

Network Setup

This section determines if the media connector’s IP address is obtained

automatically from a DHCP server, such as your network router (Automatic

Configuration - DHCP), or set manually (Static IP).

Device IP If your network has a DHCP server, such as your network router,

assigning IP addresses to your network devices, then keep the default,

Automatic Configuration - DHCP. The media connector will request an

IP address from the DHCP server (usually the network router). If no DHCP

server is found, then the media connector will use its default static IP address,

10.100.1.1, until it detects a DHCP server and is assigned a dynamic IP address.

If you want to set a permanent static IP address for the media connector, then

select Static IP.

If you select Static IP, then complete the following fields:

• Static IP Address Enter a unique IP address that will be used to access the

browser-based utility.

• Subnet Mask Enter the subnet mask of your wired network.

• Default Gateway Enter the IP address of the default gateway for your

network (in most cases, this is your router).

Click Save Settings to apply your changes, or click Cancel Changes to cancel

your changes.

Wireless > Basic Wireless Settings

Use the Basic Wireless Settings screen to configure the media connector’s basic

wireless and security settings.

There are two ways to configure the media connector’s settings, manual and

Wi-Fi Protected Setup. Wi-Fi Protected Setup is a feature that makes it easy to

set up your wireless network. If your network router supports Wi-Fi Protected

Setup and uses WPA or WPA2 security, then you can use Wi-Fi Protected Setup

to automatically connect the media connector.

Configuration View To manually configure your wireless network, select

Manual. Refer to Basic Wireless Settings, page 8. To use Wi-Fi Protected

Setup, select Wi-Fi Protected Setup. Refer to Wi-Fi Protected Setup, page 9.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 288 289

Pas de commentaire

Cisco WUMC710 Manuel d'utilisateur Page 76