Cisco WUMC710 Manuel d'utilisateur Page 83

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 289
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 82
14
Troubleshooting
Linksys WUMC710
14
WUMC710
Your computer or other wired, Ethernet device cannot communicate with the
wireless router.
1.
Access the media connectors browser-based utility.
2.
On the Basic Wireless Settings screen, make sure the Network Name (SSID)
matches the name of your wireless network.
3.
Make sure the security settings (WPA, WPA2, or WEP) match the security
settings of your wireless network.
The media connector’s IP address needs to be changed.
If the media connector is connected to a network with a DHCP server (usually
the network router), then the media connector will obtain its IP address from
the DHCP server. If there is no DHCP server, then the media connector will use
its default, static IP address, 10.100.1.1.
If you want the media connector to always use a static IP address, then follow
these instructions:
1.
Access the media connectors browser-based utility.
2.
Click the Setup tab, then open the Basic Setup page.
3.
From the Network Setup drop-down menu, select Static IP.
4.
Complete the Static IP Address, Subnet Mask, and Default Gateway fields.
5.
Click Save Settings.
The media connector-enabled computer or other wired, Ethernet device will
not communicate with another wireless-enabled device (such as a computer
or printer).
Check the following:
Make sure the wireless-enabled device is on the same wireless network
as the computer or other wired, Ethernet device connected to the media
connector.
Make sure that the same Network Name (SSID) is used for all devices on
the wireless network.
Make sure all devices are on the same IP network, using compatible IP
addresses.
The browser-based utility does not accept your password.
Check the following:
The password is case-sensitive. Make sure that you are using the correct
case(s) when entering the password.
If you forget your password, you can reset the media connector to its
factory defaults.
Press and hold the media connectors Reset button for approximately
five seconds; the password will be reset to its factory default, admin. All
other media connector settings will be reset to the factory defaults as
well. (To access the browser-based utility, enter admin in the Password
field.)
After you make changes through the browser-based utility, the new settings
are not displayed on-screen.
On your web browser, click Refresh. If the new settings are not displayed, then
follow these instructions:
1.
Unplug the power adapter from the media connector.
2.
Wait five seconds, and then plug the power adapter back into the media
connector.
3.
On your web browser, click Refresh.
WEB
If your questions are not addressed here, refer to the Linksys
website at Linksys.com/support
Troubleshooting
Vue de la page 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 288 289

Commentaires sur ces manuels

Pas de commentaire