Cisco 3200 Manuel d'utilisateur Page 215
- Page / 282
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
12-7
Cisco TelePresence System 3200
OL-14521-01
Chapter 12 Field-Replaceable Unit Guide
Replacing a Plasma Display—Part Number CTS-DISP-65-GEN4=
Tip
A round-head Allen bit allows the bit to work at an angle instead of only straight out, which is
helpful in tight spots.
•
Manual screwdrivers, Phillips and flat head types
•
Metric wrenches, 10 to 15 mm
•
9/64-inch Allen wrench (supplied with speakers)
•
0.9mm Allen wrench for camera lens adjustments (if the lens uses a thumbscrew no tools are
required)
•
Level
•
Masking tape
•
* Tie wraps
•
Laptop computer attached to network
•
* Step ladder
* Recommended for best results
Removing Audio Components
Caution
Take care not to mar or introduce smudges or dirt to the surface of the projector screen.
Step 1
Power off the system by completing turning off the following units:
•
The two left PDUs on the left accessory cabinet
•
The single right PDU on the right accessory cabinet
•
The auxiliary control unit on the center display structure
Caution
Make sure all system power is turned off before beginning this disassembly.
Step 2
Remove the Projector screen by performing one of the following actions:
•
If your projector screen is slightly recessed and uses black side trims, complete the following steps:
a.
Remove the side trims from the edges of the display.
Be careful not to mar the screen when you perform this step.
b.
Use an open-ended wrench to loosen the feet on the bottom of the screen, and lower the screen.
c.
After you have created a gap of approximately 1/2 inch (1 centimeter) between the screen and
the display shelf, detach the holes on the top screen from the locating pins on the underside of
the display shelves and remove the screen.
•
If your projector screen does not have side trims and is flush with the display cabinet, grasp the outer
edges of the screen and pull it up and away from the Projector clips that hold the screen to the
Display shelves.
Step 3
Disconnect the Speaker cables from the Speaker terminals.
- Assembly Guide 1
- Use & Care Guide 1
- Field-Replaceable Unit Guide 1
- Contents 3
- Introduction 9
- Conventions 9
- Guidelines 10
- Related Documentation 10
- Overview 11
- Chapter 1 Overview 12
- Chapter Organization 12
- Conventions and Terminology 13
- Tools and Equipment List 13
- Tools and Equipment List 14
- Building the Display Assembly 15
- Minimum 12 inches (30.5 cm) 24
- Minimum 24 inches 24
- Leveling Alignment Points 28
- Leveling Goals 28
- Accessory Cabinet 36
- Figure 4-2 Left Display shelf 38
- Figure 4-5 Accessory Cabinet 41
- Figure 5-8 Light Cup bracket 52
- Figure 5-15 Four L-brackets 59
- Privacy Panel Assembly 70
- 22 23 24 74
- OL-14521-01 100
- Parts List 100
- Figure 7-13 Second Row PDUs 104
- Figure 7-46 Cable Cover 133
- 59” (150 cm) 135
- Elements 137
- Switch Bracket 139
- Figure 8-1 Camera Assembly 140
- Figure 8-2 Projector Assembly 141
- Figure 8-3 Projector Assembly 142
- Figure 8-4 Projector Assembly 143
- Figure 8-5 Codec Assembly 144
- Figure 8-6 Codec Assembly 145
- Figure 8-7 Codec Assembly 146
- Figure 8-8 Speaker Assembly 147
- Figure 8-9 Speaker Assembly 148
- Figure 8-10 Speaker Assembly 149
- Parts List 155
- Table Leg Power 160
- Projector Power 160
- Table Leg Signal 161
- IP Phone Signal 161
- Microphone Signal 161
- Projector Signal 161
- VGA Peripheral 161
- Floor-mounted junction box 164
- Table segment 166
- RJ45 Power over Ethernet 170
- HDMI connector 170
- Primary Codec 176
- Auxiliary Control Unit 176
- Projector 176
- Presentation Codec 177
- First-Time Setup 183
- Figure 10-1 Bootup Completed 184
- Setting Up CTS Components 186
- Setting Up the Displays 187
- Setting Up the Cameras 188
- Starting the Software Setup 189
- Setting Up CTS Components 190
- Adjusting the Zoom 191
- Focusing the Camera 194
- Large target 195
- Small target 195
- Focus ring 196
- Zoom ring 196
- Troubleshooting Cameras 198
- Setting Up the Speakers 200
- Setting Up the Microphones 200
- Troubleshooting Microphones 201
- Setting Up the Projector 202
- Other Devices 205
- Cleaning the Camera lens 208
- Maintaining the Projector 208
- Powering On the System 212
- CTS3K-CAM-CLST-G2= 213
- CTS-DISP-65-GEN4= 214
- Removing Audio Components 215
- Removing the Camera Cluster 216
- Removing the Left Door 216
- Removing a Display Shelf 216
- On/Off Switch 220
- AC inlet 220
- Powering Off the System 226
- Replacement Bulbs 230
- Replacing a Light Fixture 230
- CTS-AV-EXP= 231
- CTS-LIGHT-CTRL= 232
- CP-7975G-CTS= 233
- Replacing the Projector Lamp 233
- Replacing a Display Shelf 236
- Replacing a Display Shelf 237
- 53-2855-xx 245
- CTS3K-ACC2-KIT 247
- CTS3K-CAM-CLST-G2 248
- CTS32-ACC-KIT 252
- CTS32-M-2TBL-G2, 69-1853-xx 253
- CTS-CODEC-SEC 258
- CTS3K-FUR-MAPLE 260
- CTS3K-LIGHT-STR 260
- Equipment 265
- Asia Pacific 266
- Argentina 267
- Australia 268
- Central Europe 269
- China 270
- India, UAE, South Africa 271
- Israel 272
- Italy 273
- Japan 274
- North America 275
- Switzerland 276
- United Kingdom 277
- United Kingdom 278
- Dimensions and Description 279
Produits connexes et manuels pour Accessoires pour ordinateurs Cisco 3200
(120 pages)
(74 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.525 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels