Cisco 3200 Manuel d'utilisateur télécharger pdf (Page 240)

12-32

Cisco TelePresence System 3200

OL-14521-01

Chapter 12 Field-Replaceable Unit Guide

Replacing a Second Row Table Top Section

Step 18

Insert the draw bolts or cam locks and tighten them between the new table top section and the adjoining

table top sections. See Chapter 6, “Building the First Row Table Assembly” for the location of the draw

bolts or cam locks.

Step 19

Attach the legs to the table top sections with the screws. See Chapter 6, “Building the First Row Table

Assembly” for the location of the table legs and screw attachment locations.

Step 20

Reconnect the microphone to the new table top section.

Step 21

Route the microphone cable to the audio/video extension unit and connect the cable to the unit.

See Figure 6-13 for microphone installation instructions.

Step 22

Close the table door.

Step 23

If you removed the table door, replace the door.

See Figure 6-14 for table door installation instructions.

Replacing a Second Row Table Top Section

Complete these steps to replace a second row table top section.

Required Information, Tools, and Equipment

To remove and replace a second row table top, you need the following tools:

•

Medium and large Phillips screwdriver

•

10 mm wrench

Tip

A 10 mm open end ratcheting wrench is useful to loosen and tighten the draw bolts or cam locks.

•

Furniture sliders (recommended but not required)

Note

Furniture sliders are flat plastic pieces that you place under the table legs before you move the

table. Using furniture sliders can make moving the second row table easier.

Note

Make sure to retain all screws, connectors, and other parts during the disassembly.

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 281 282

Pas de commentaire

Cisco 3200 Manuel d'utilisateur Page 240