Cisco 3200 Manuel d'utilisateur Page 201

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 282
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 200
10-19
Cisco TelePresence System 3200
OL-14521-01
Chapter 10 First-Time Setup
Setting Up CTS Components
Step 3
Lightly tap each microphone and watch the audio meter on the corresponding display screen to see that
sound registers.
This step verifies that the microphones are connected and operating properly.
Step 4
Calibrate the microphones by clicking the Microphone Calibration button.
Note
The room must be completely quiet to properly calibrate microphones and ensure that camera switching
is properly enabled.
Tip
Before clicking the Microphone Calibration button, you can leave the room and close the door to insure
complete silence in the room.
Step 5
Click Refresh Microphones Status to update the on/off status of all microphones.
Step 6
Click Stop when setup is complete.
Troubleshooting Microphones
Use Table 10-4 to troubleshoot problems with microphones.
Ta b l e 10-4 Troubleshooting Chart for Microphone Problems
Problem Possible Cause Possible Solution
Sound is muffled. Something near or on the
microphone is distorting the
sound.
Move objects away from the
microphone.
Sound registers at the wrong
microphone.
Microphone cable is not
connected to its corresponding
codec.
Check that the cable from the
microphone is plugged into the
correct receptor on the codec.
Plug all microphones into the
primary codec.
Vue de la page 200
1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 281 282

Commentaires sur ces manuels

Pas de commentaire