Cisco 3200 Manuel d'utilisateur Page 236
- Page / 282
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
12-28
Cisco TelePresence System 3200
OL-14521-01
Chapter 12 Field-Replaceable Unit Guide
Replacing a Display Shelf
Step 3
Remove the PDU by performing one of the following steps:
•
Remove a PDU from the accessory cabinet or the first row center privacy panel by removing the
mounting screws.
•
Remove the PDU from the second row table section by removing the plastic knob screws on the
underside of the table, removing the privacy panel, and removing the PDU that is placed in the lower
cable gutter.
Step 4
Attach the replacement PDU.
Step 5
Plug in the jumper cords that were removed and turn the power switch to the On position.
Step 6
Plug the PDU power cord into the wall receptacle.
Step 7
Open a browser on a computer connected to the network.
Step 8
Get the IP address for the system codec as follows:
a.
On the IP phone, locate Manual at the bottom of the screen and press the soft key.
Note
If you cannot locate the Manual button, proceed to Step b.
b.
Locate Info at the bottom of the screen and press the soft key.
c.
Scroll down to the IP Address listing and copy the address.
Step 9
Type in the IP address of the system codec. Log in to the system by entering the following information:
a.
In the Admin field, type admin.
b.
In the Password field, type cisco.
Note
If your administrator has changed the user name or password, enter those values.
Step 10
Click Login.
Step 11
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
window) is Enabled/Up.
Step 12
Choose System Restart to perform a software reset.
Refer to the Cisco TelePresence System Administrator's Guide for your software release for more
information.
Replacing a Display Shelf
The display shelves are the table sections that sit directly below the display screens.
Required Information, Tools, and Equipment
To remove and replace a display shelf, you need the following tools:
•
Medium and large Phillips screwdriver
•
10 mm wrench
- Assembly Guide 1
- Use & Care Guide 1
- Field-Replaceable Unit Guide 1
- Contents 3
- Introduction 9
- Conventions 9
- Guidelines 10
- Related Documentation 10
- Overview 11
- Chapter 1 Overview 12
- Chapter Organization 12
- Conventions and Terminology 13
- Tools and Equipment List 13
- Tools and Equipment List 14
- Building the Display Assembly 15
- Minimum 12 inches (30.5 cm) 24
- Minimum 24 inches 24
- Leveling Alignment Points 28
- Leveling Goals 28
- Accessory Cabinet 36
- Figure 4-2 Left Display shelf 38
- Figure 4-5 Accessory Cabinet 41
- Figure 5-8 Light Cup bracket 52
- Figure 5-15 Four L-brackets 59
- Privacy Panel Assembly 70
- 22 23 24 74
- OL-14521-01 100
- Parts List 100
- Figure 7-13 Second Row PDUs 104
- Figure 7-46 Cable Cover 133
- 59” (150 cm) 135
- Elements 137
- Switch Bracket 139
- Figure 8-1 Camera Assembly 140
- Figure 8-2 Projector Assembly 141
- Figure 8-3 Projector Assembly 142
- Figure 8-4 Projector Assembly 143
- Figure 8-5 Codec Assembly 144
- Figure 8-6 Codec Assembly 145
- Figure 8-7 Codec Assembly 146
- Figure 8-8 Speaker Assembly 147
- Figure 8-9 Speaker Assembly 148
- Figure 8-10 Speaker Assembly 149
- Parts List 155
- Table Leg Power 160
- Projector Power 160
- Table Leg Signal 161
- IP Phone Signal 161
- Microphone Signal 161
- Projector Signal 161
- VGA Peripheral 161
- Floor-mounted junction box 164
- Table segment 166
- RJ45 Power over Ethernet 170
- HDMI connector 170
- Primary Codec 176
- Auxiliary Control Unit 176
- Projector 176
- Presentation Codec 177
- First-Time Setup 183
- Figure 10-1 Bootup Completed 184
- Setting Up CTS Components 186
- Setting Up the Displays 187
- Setting Up the Cameras 188
- Starting the Software Setup 189
- Setting Up CTS Components 190
- Adjusting the Zoom 191
- Focusing the Camera 194
- Large target 195
- Small target 195
- Focus ring 196
- Zoom ring 196
- Troubleshooting Cameras 198
- Setting Up the Speakers 200
- Setting Up the Microphones 200
- Troubleshooting Microphones 201
- Setting Up the Projector 202
- Other Devices 205
- Cleaning the Camera lens 208
- Maintaining the Projector 208
- Powering On the System 212
- CTS3K-CAM-CLST-G2= 213
- CTS-DISP-65-GEN4= 214
- Removing Audio Components 215
- Removing the Camera Cluster 216
- Removing the Left Door 216
- Removing a Display Shelf 216
- On/Off Switch 220
- AC inlet 220
- Powering Off the System 226
- Replacement Bulbs 230
- Replacing a Light Fixture 230
- CTS-AV-EXP= 231
- CTS-LIGHT-CTRL= 232
- CP-7975G-CTS= 233
- Replacing the Projector Lamp 233
- Replacing a Display Shelf 236
- Replacing a Display Shelf 237
- 53-2855-xx 245
- CTS3K-ACC2-KIT 247
- CTS3K-CAM-CLST-G2 248
- CTS32-ACC-KIT 252
- CTS32-M-2TBL-G2, 69-1853-xx 253
- CTS-CODEC-SEC 258
- CTS3K-FUR-MAPLE 260
- CTS3K-LIGHT-STR 260
- Equipment 265
- Asia Pacific 266
- Argentina 267
- Australia 268
- Central Europe 269
- China 270
- India, UAE, South Africa 271
- Israel 272
- Italy 273
- Japan 274
- North America 275
- Switzerland 276
- United Kingdom 277
- United Kingdom 278
- Dimensions and Description 279
Produits connexes et manuels pour Accessoires pour ordinateurs Cisco 3200
(120 pages)
(74 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.593 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels