Cisco OL-4015-08 Manuel d'utilisateur Page 670

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 678
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 669
1022
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(30)S
Conditions: This symptom is observed on a Cisco 10000 series that runs Cisco IOS
Release 12.0(27)S2 when a Fast Ethernet interface is configured to use DHCP via the ip address
negotiated command.
Workaround: Do not configure the ip address negotiated command. Rather, configure a specific IP
address.
CSCeg03055
Symptoms: Sampled NetFlow may stop functioning.
Conditions: This symptom is observed on a Cisco 12000 series that is configured with an Engine 4+
4-port OC-48 line card.
Workaround: Disable and re-enable Sampled NetFlow.
CSCeg03180
Symptoms: A line card in slot 15 is stuck in the WAITRTRY state.
Conditions: This symptom is observed on a Cisco 12816 that is configured with dual RPs when an
RP switchover followed by a CSC switchover occurs.
Workaround: Reload the router.
Alternate Workaround: Power down and power up the router.
CSCeg03606
Symptoms: Multicast VPN (MVPN) traffic does not resume.
Conditions: This symptom is observed on a Cisco 12000 series that runs a Cisco IOS interim release
for Release 12.0(30)S and that functions as a PE router that is configured for MVPN.
Workaround: Enter the clear ip mroute command.
CSCeg06154
Symptoms: A router crashes when you delete an MPLS subinterface by entering the no interface
command.
Conditions: This symptom is observed when the mpls ip command is configured on the same MPLS
subinterface. For example, consider a router with the following configuration:
interface atm1/0.1 mpls
mpls ip
When you enter the no interface atm1/0.1 mpls command, the router crashes.
Workaround: There is no workaround.
CSCeg06618
Symptoms: A 6-port channelized T3 line card and a 2-port Channelized OC-3 line card may
continuously generate the following error message:
%LC_CX3-2-PLIM_CPU_CRASHED: PLIM CPU Tofab755 - plim reset
Controllers and interfaces do not recover.
Conditions: This symptom is observed on a Cisco 12000 series and occurs because of a problem with
the recovery mechanism following a forced reset of the PLIM component of the line card. The
symptom is visible only if another problem indirectly triggers a forced reset of the PLIM
component.
Workaround: There is no workaround. To recover the affected line card, reload the line card by
entering hw-module slot slot-number reload command.
Vue de la page 669

Commentaires sur ces manuels

Pas de commentaire