Cisco OL-4015-08 Manuel d'utilisateur Page 666

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 678
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 665
1018
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(30)S
Conditions: This symptom is observed when the headend of the TE tunnel is a third-party router that
has the no cspf command configured for the label switched path (LSP) and when the tunnel midpoint
is a Cisco router that runs Cisco IOS Release 12.0(25)S1. The symptom occurs when the link
downstream (that is, towards the tailend of the tunnel) on the Cisco router fails because the interface
on either side of the link is shut down.
In addition, note that the third-party router does not increment the LSP ID when it receives a
message, nor does it send a PathTear message in response to a PathErr message.
Possible Workaround: Use an explicit path on the third-party router but without the no cspf
command enabled.
CSCef81501
Symptoms: When L2TPv3 tunnels are scaled and the IP Path MTU Discovery feature is enabled, a
memory leak and crash may occur.
Conditions: This symptom is observed when multiple Xconnect statements are applied in
conjunction with the IP Path MTU Discovery feature in the pseudowire class.
Workaround: Do not enable the IP Path MTU Discovery feature in an L2TPv3 configuration.
CSCef81555
Symptoms: The running configuration does not show the correct policing rate if the rate is
configured to be larger than 4,200,000,000 bps.
Conditions: This symptom is observed on a Cisco 12000 series that runs an interim release for
Cisco IOS Release 12.0(30)S.
Workaround: There is no workaround.
CSCef83864
Symptoms: A Cisco 10000 series reloads unexpectedly.
Conditions: This symptom is observed when 750 VRFs are configured.
Workaround: There is no workaround.
CSCef84347
Symptoms: When an input QoS policy is applied on a main interface and subinterface of an Engine 3
ATM line card, the QoS policy works on the main interface but not on the subinterface.
Conditions: This symptom is observed on a Cisco 12000 series that runs an interim release for
Cisco IOS Release 12.0(30)S when a QoS policy is applied to a layer-2 VC. Layer-3 VCs work fine.
Note that this caveat is resolved in Release 12.0(30)S.
Workaround: There is no workaround.
CSCef86176
Symptoms: The following CLI commands are missing from a Cisco 12000 series:
router(config)#map-class frame-relay r
router(config-map-class)#frame-relay ?
adaptive-shaping Adaptive traffic rate adjustment, Default = none
bc Committed burst size (Bc), Default = CIR
be Excess burst size (Be), Default = 0 bits
cir Committed Information Rate (CIR), Default = 56000 bps
custom-queue-list VC custom queueing
fecn-adapt Enable Traffic Shaping reflection of FECN as BECN
mincir Minimum acceptable CIR, Default = 1/2 CIR
Vue de la page 665
1 2 ... 661 662 663 664 665 666 667 668 669 670 671 ... 677 678

Commentaires sur ces manuels

Pas de commentaire