Cisco OL-4015-08 Manuel d'utilisateur Page 499

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 678
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 498
851
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(31)S
Conditions: This symptom is observed on a Cisco 12000 series that runs the k4p-mz image of a
Cisco IOS interim release for Release 12.0(30)S. However, this caveat is resolved in
Release 12.0(30)S.
Workaround: Bring up the locally switched DLCI by deleting and reconfiguring the xconnect
command.
CSCeg15191
Symptoms: An OC192E/POS-IR-SC line card resets with the following error messages:
%MBUS_SYS-3-NOBUFFER: Message from slot 3 in stream 1 dropped
%MDS-2-LC_FAILED_IPC_ACK: RP failed in getting Ack for IPC message of size 232 to LC
in slot 3 with sequence 47350, error = timeout
%FIB-3-FIBDISABLE: Fatal error, slot 3: IPC Failure: timeout
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(28)S1.
Workaround: There is no workaround.
CSCeg16739
Symptoms: A Cisco 10720 crashes when you add and remove a large IPv6 ACL very quickly.
Conditions: This symptom is observed only on a Cisco 10720 that has a large 500-line ACL while
the ACL is compiling.
Workaround: Wait until the ACL has compiled before you remove the ACL.
CSCeg16790
Symptoms: A policy map that causes AAL5 IP to enable the set precedence 4 command does not
function. Note that a policy map that causes ATM to enable the set mpls experimental imposition
works fine.
Conditions: This symptom is observed on a Cisco 12000 series Engine 2 8-port OC-3 ATM line card
when a policy map is configured on a PVC that performs Layer-3 forwarding of AAL5 packets.
Workaround: There is no workaround.
CSCeg19298
Symptoms: A router may crash when you enter the show running-config command.
Conditions: This symptom is observed when a bundle is configured on an ATM interface and when
you enter the show running-config after you have entered the no protocol protocol-address
command for the bundle.
Workaround: There is no workaround.
CSCeg20700
Symptoms: When an Engine 2 ATM line card is configured with the Carrier Supporting Carrier
feature and egress traffic is being processed, the following error message may be generated on the
line card and the line card may reset:
%QM-4-STUCK: Port 2 Queue mask 0x1
Conditions: This symptom is observed on a Cisco 12000 series that runs the gsr-p-mz image of a
Cisco IOS interim release for Release 12.0(31)S. However, this caveat is resolved in
Release 12.0(31)S.
Workaround: There is no workaround.
Vue de la page 498
1 2 ... 494 495 496 497 498 499 500 501 502 503 504 ... 677 678

Commentaires sur ces manuels

Pas de commentaire