Cisco OL-4015-08 Manuel d'utilisateur Page 216

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 678
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 215
568
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S8
Recovery: In case of a PLIM cpu reset, if the controller stays in the down state, the line card must
be reloaded with the "test mbus <slot> power off/on" commands.
CSCsj14388
Symptoms: BFD session goes down on removing and adding ip address from bfd enabled interface.
Conditions: This symptom is observed on a GSR router loaded with Cisco IOS Release 12.0(32)sy
image. After BFD sessions are estalished on adding and removing ip address couple of times the
BFD sessions go down
Workaround: Reload the routers.
CSCsj15162
Symptoms: The following error message occurs on CHOC12/DS1-IR-SC linecard indicating that
the PLIM is reset:
%LC_CX3-2-PLIM_RESET: PID 49165, CAUSE 0
Conditions: When shutdown / no shutdown was executed on many multilink ppp bundles
continuously.
Workaround: There is no workaround.
CSCsj25144
Some CEF related commands on a previously removed sub interface are (wrongly) retained when
configuring a new sub-interface. This is also true for sub-interfaces that are being reused.
Symptoms: The following CEF related commands are retained from previously removed
sub-intrefaces:
- ip cef accounting non-recursive external - ip load-sharing per-packet
For example:
Router(config-if)#int Serial3/3/1:0.100 point <<< ADD .100
Router(config-subif)#ip cef accounting non-recursive external
Router(config-subif)#ip load-sharing per-packet
Router(config-subif)#no int Serial3/3/1:0.100 <<< REMOVE
Router(config)#int Serial3/3/1:0.200 point <<< ADD .200
Router(config-subif)#do sh run int Serial3/3/1:0.200 Building configuration...
Current configuration : 166 bytes ! interface Serial3/3/1:0.200 point-to-point
no ip directed-broadcast ip load-sharing per-packet <<<<
ip cef accounting non-recursive external <<<<
no ip mroute-cache end
Conditions: This issue is observed in 12.0S on reused and new ATM or serial sub-interface on a
GSR.
Workaround: Verify sub-interface configuration and if configuration cannot be deleted on that
sub-interface, delete this sub-interface then create a dummy sub-interface which will pull that
configuration. Then recreate the prior sub-interface.
The problem is not seen in 12.2S branches and later.
CSCsj28901
Symptoms: When changing mtu on 4xOC3-V2 SPA in SIP-501, the following crash may be seen:
%RP-3-CARVE_FAIL: FrFab BMA, slot 9 %RP-3-COREDUMP: Core dump incident on slot 9,
error: Safe FrFab buffer carve failure %RP-4-RSTSLOT: Resetting the card in the slot: 9,Event:
linecard error report %LCINFO-3-CRASH: Line card in slot 9 crashed
Conditions: This symptom is observed on a Cisco 12000 series router that runs the c12kprp-p-mz
image of Cisco IOS pre-Release 12.0(32)SY4.
Workaround: There is no workaround.
Vue de la page 215
1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 677 678

Commentaires sur ces manuels

Pas de commentaire