Cisco OL-4015-08 Manuel d'utilisateur Page 180

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 678
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 179
532
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S9
CSCsm87206
Symptoms: Alternate PVC may go down if you reload the local PE line card 10 seconds after the
remote PE line card.
Conditions: Occurs with Cisco 12000 router loaded with Cisco IOS Release 12.0(32)sy0i image.
Local PE is configured with 4xCT3, and remote PE is configured with 1xSTM1 and L2tpv3.
Workaround: Reload with long delay between local and remote PE’s LC
Resolved Caveats—Cisco IOS Release 12.0(32)S9
Cisco IOS Release 12.0(32)S9 is a rebuild of Cisco IOS Release 12.0(32)S. The caveats listed in this
section are resolved in Cisco IOS Release 12.0(32)S9 but may be open in previous Cisco IOS releases.
This section describes only severity 1, severity 2, and select severity 3 caveats.
Basic System Services
CSCef32207
Symptoms: The no snmp trap link-status command is not available.
Conditions: Occurs only in the Frame Relay sub-interface.
Workaround: There is no workaround
CSCsd59610
Symptoms: Cisco 7500 router with a RSP8 running Cisco IOS Release 12.0(27)S5b may experience
traceback errors when the command /jointfilesconvert/415844/bgp regexp deterministic is issued.
%SYS-4-REGEXP: new engine: regexp compilation had failed.
-Process= "BGP Router", ipl= 0, pid= 172
-Traceback= 40E601F4 40E5E8C0 40E5F950 40E5E128 4060BD4C 407CCF14 407CD440 407CE4A0
407A944C 407AB594 407ABE90 4079BA34
Conditions: Traceback appears after issuing the command /jointfilesconvert/415844/bgp regexp deterministic.
Workaround: Disable /jointfilesconvert/415844/bgp regexp deterministic.
CSCse68904
Symptoms: IPC-INVALID with tracebacks seen after switchover.
Conditions: RPR-PLUS is configured on Cisco 7500 router.
Workaround: There is no workaround.
CSCsg39295
Symptoms: Password information may be displayed in a Syslog message as follows:
%SYS-5-CONFIG_I: Configured from scp://userid:[email protected]/config.txt by console
Conditions: When using SNMP to modify a configuration by means of the
CISCO-CONFIG-COPY-MIB, selection of ConfigCopyProtocol of SCP or FTP may result in the
password being exposed in a syslog message.
Workaround: When using SNMP to modify a configuration by means of the
CISCO-CONFIG-COPY-MIB, use the ConfigCopyProtocol of RCP to avoid exposure of the
password.
Vue de la page 179
1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 677 678

Commentaires sur ces manuels

Pas de commentaire