16
Connect the Console and the Auxiliary Y-Cables
Connect the RSP
The console and auxiliary Y-cables allow you to
simultaneously connect the console or auxiliary
ports on two RSP2s, RSP4s, or RSP8s, to a single
console terminal, or external auxiliary device. These
are configured as system master and slave in slots 2
and 3 in the Cisco 7507.
Step 1 Connect the DB-25 female end of the
Y-cable to the console terminal device.
Step 2 Connect one DB-25 male end of the
Y-cable to an RSP or other external
auxiliary device.
Step 3 Repeat Step 2 for the other RSP or other
external device.
H9720
CONSOLE CONSOLE
DB-2
DB-2
ole terminal
Consol
to con
RSPs i
Step 1 Connect the DB-25 male end of the
Y-cable to the external auxiliary
equipment.
Step 2 Connect one DB-25 female end of the
Y-cable to auxiliary ports on an RSP in an
RSP slot.
Step 3 Repeat Step 2 for the auxiliary ports on a
second RSP in an RSP slot.
Step 4 Connect the interface processors or VIPs
to the external network. Refer to the
appropriate processor module manual,
such as the Route Switch Processor
(RSP4/4+) Installation and Configuration
Guide.
H9721
AUXILIARY AUXILIARY
DB-25 f
DB-25 f
xternal
equipment
Auxiliar
to auxili
RSPs i
Commentaires sur ces manuels