Cisco 7507 Manuel d'utilisateur télécharger pdf (Page 25)

Perform a Basic Conﬁguration Using Conﬁguration Mode

Start and Conﬁgure the System

At the reboot, the following example appears:

Any interface listed with OK? value "NO" does

not have a valid configuration.

Interface IP-Address OK? Method Status

Protocol

Ethernet0/0 unassigned NO not set down down

Serial1/0 unassigned NO not set down down

Step 1 Enter the conﬁgure terminal command at

the enable prompt to enter conﬁguration

mode from the terminal, as follows:

Router# configure terminal

Enter configuration commands, one per line.

End with CNTL/Z.

Router(config)#

Step 2 Enter the interface type slot/port

command at the enable prompt to enter

interface conﬁguration mode, as follows:

Router(config)# interface serial

slot/port

Router(config-if)#

Step 3 Press Ctrl-Z to exit conﬁguration mode.

Step 4 At the # prompt, enter the copy

running-conﬁg startup-conﬁg command

to save the conﬁguration to NVRAM as

follows:

Hostname# copy running-config startup-config

YourCisco 7507router isnow minimally conﬁgured

and ready to use. If you want to modify the

parameters after the initial conﬁguration, use the

setup command. To perform more complex

conﬁgurations, use the conﬁgure command. For

more information on additional interface

conﬁguration and information on more speciﬁc

system conﬁgurations, refer to the Cisco 7500 Series

Installation and Conﬁguration Guide.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 43 44

Pas de commentaire

Cisco 7507 Manuel d'utilisateur Page 25