Cisco 7507 Manuel d'utilisateur télécharger pdf (Page 21)

Perform a Basic Conﬁguration Using Setup

Start and Conﬁgure the System

Note Therouter’sserial(WAN)cableshouldnotbe

connected to the CSU/DSU unless you are planning

to use AutoInstall. If you are using the console

Y-cable that shipped with your router, use either of

the two DB-25 male plug ends of the Y-cable.

Step 1 Select the protocols supported on your

interfaces. For Internet Protocol (IP)-only

installations, accept the default values. A

typical minimal conﬁguration using IP,

IPX, and AppleTalk follows:

Configuring global parameters:

Enter host name [Router]: Router

Step 2 Enter the enable secret password and the

enable password when the following is

displayed:

The enable secret is a one-way cryptographic

secret used instead of the enable password

when it exists.

Enter enable secret: barney

The enable password is used when there is no

enable secret and when using older software

and some boot images.

Enter enable password: betty

Step 3 Enter yes or no to accept or refuse SNMP

management:

Configure SNMP Network Management? [yes]: yes

Community string [public]:

Step 4 Enter no to refuse to enable CLNS:

Configure CLNS? [no]: no

Step 5 Enter yes to enable routing on AppleTalk

and IPX:

Configure AppleTalk? [no]: yes

Multizone networks? [no]: yes

Configure IPX? [no]: yes

Step 6 Enter no to refuse to enable Vines, XNS,

DECnet, or bridging:

Configure Vines? [no]: no

Configure XNS? [no]: no

Configure DECnet? [no]: no

Configure bridging? [no]: no

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Pas de commentaire

Cisco 7507 Manuel d'utilisateur Page 21