Cisco 2525 Guide de l'utilisateur télécharger pdf (Page 81)

Configuring the Cisco 2524 and Cisco 2525 Routers 4-19

Configuring the Router

Take the following steps to conﬁgure the fractional T1/T1 DSU/CSU WAN module for a

typical leased-line connection, substituting the correct addresses and host names as

appropriate for your network:

Step 1 Enter enable mode:

Router> enable

password:

enablepassword

Step 2 Enter conﬁguration mode:

Router# config term

Router(config)#

Step 3 Assign an IP address to the serial port on the module:

Router(config)# interface serial

port_number

Router(config-if)# ip address

ipaddress subnetmask

Router(config-if)# no keepalive

Step 4 Enter the framing type and line code type, substituting framing_type with sf

(Superframe) or esf (Extended Superframe) and linecode_type with ami (alternate

mark inversion) or b8zs (bipolar eight zero substitution):

Router(config-if)# service-module t1 framing

framing_type

Router(config-if)# service-module t1 linecode

linecode_type

Step 5 If you are using fractional T1 service, enter the time slot range and speed. In the

following example, the time slot range is from 1 to 20 and the speed is 64-kbps:

Router(config-if)# service-module t1 timeslots 1-20 speed 64

Step 6 Return to user EXEC mode:

Router(config-if)# exit

Router(config)# exit

Router# exit

Router>

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 165 166

Pas de commentaire

Cisco 2525 Guide de l'utilisateur Page 81