Cisco InfiniBand 4x Guide de l'utilisateur télécharger pdf (Page 163)

Chapter 7. Configuring the Cisco 3012 InfiniBand to Ethernet gateway 149

4. When the mgmt-ib interface is configured, proceed to create BG1 and BG2.

Note that for redundancy to work, the Bridge groups should be configured similarly. Same

p_key on the InfiniBand side and same VLAN (or untagged) on upstream side.

To begin the process of creating bridge group BG1 and BG2, use the example starting at

step 1 on page 125 and create BG1, then repeat the process for creating bridge group

BG2, using ID2, name BG2, and for the Ethernet port 8/1 and for the InfiniBand port 8/2.

Figure 7-23 and Figure 7-24 on page 150 show the two groups, just prior to clicking Add

(as always, remember to configure the Forwarding tab and Subnet tab for each group per

the example starting with step 1 on page 125).

Figure 7-23 Bridge group BG1 ready to be added

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 173 174

Pas de commentaire

Cisco InfiniBand 4x Guide de l'utilisateur Page 163