Cisco DMP100 Guide de l'utilisateur télécharger pdf (Page 23)

2. Field calibration

2.6 Field adjust

Why do Field adjust

To correct the uniformity of LED wall, a new LMT brightness value of the selected frame needs to be set to calibrate it.

WARNING: Due to the possibility of making some error in modifying LMT data, So, M ust back up the raw LMT

data on controller PC before modifying it

Backup/Restore LMT Data

1. To backup or restore LMT Data, press “Backup/Restore LMT Data” In the pop up dialog

2. Fill the start tile number in the “from tile” text, the end tile number in the “To tile” text. The start and end frame number is ﬁlled in

the “frame” text respectively.

3. Press “Backup LMT data”, and select the save folder, LMT data of the selected tile/frame will be saved.

Or,

Press “Restore LMT data”, and select the restore folder

4. To get the current process, see the progress bar.

5. To view the running log, see the list box at the bottom of the dialog

(1)

(2)

(3)

(4)

(5)

(3)

log dialog

Image 2-15

Backup/Restore LMT Data

Select Frame

1. Input the tile address in “Tile address” text.

2. In “Select Frame”, frame numbers of the tile are shown in table. Click on the number in the table and there will be a red colored

outline around it

R59770395 FIELD CALIBRATION SOFTWARE (FCS-100) 08/05/09

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

Pas de commentaire

Cisco DMP100 Guide de l'utilisateur Page 23