Cisco Cisco Access Registrar 4.2 Spécifications télécharger pdf (Page 526)

100

101

12-18

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 12 Configuring Hybrid REAPWireless Device Access

Configuring Hybrid-REAP Groups

Step 8 To add an access point to the group, click Add AP. Additional fields appear on the page under “Add AP”

(see Figure 12-12).

Figure 12-12 HREAP Groups > Edit Page

Step 9 Perform one of the following:

• To choose an access point that is connected to this controller, check the Select APs from Current

Controller check box and choose the name of the access point from the AP Name drop-down box.

Note If you choose an access point on this controller, the MAC address of the access point is

automatically entered in the Ethernet MAC field to prevent any mismatches from occurring.

• To choose an access point that is connected to a different controller, leave the Select APs from

Current Controller check box unchecked and enter its MAC address in the Ethernet MAC field.

Note If the hybrid-REAP access points within a group are connected to different controllers, all

of the controllers must belong to the same mobility group.

Step 10 Click Add to add the access point to this hybrid-REAP group. The access point’s MAC address and name

appear at the bottom of the page.

Note If you want to delete an access point, hover your cursor over the blue drop-down arrow for that

access point and choose Remove.

Step 11 Click Apply to commit your changes.

Step 12 Repeat Step 9 through Step 11 if you want to add more access points to this hybrid-REAP group.

Step 13 Click Save Configuration to save your changes.

Step 14 Repeat this procedure if you want to add more hybrid-REAP groups.

1 2 ... 521 522 523 524 525 526 527 528 529 530 531 ... 635 636

Commentaires sur ces manuels

Pas de commentaire

Cisco Cisco Access Registrar 4.2 Spécifications Page 526

Commentaires sur ces manuels