Cisco Cisco Access Registrar 4.2 Spécifications télécharger pdf (Page 144)

100

101

4-46

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 4 Configuring Controller SettingsWireless Device Access

Configuring Quality of Service

Figure 4-16 Edit QoS Role Data Rates Page

Note The values that you configure for the per-user bandwidth contracts affect only the amount of

bandwidth going downstream (from the access point to the wireless client). They do not affect

the bandwidth for upstream traffic (from the client to the access point).

Step 6 To define the average data rate for TCP traffic on a per user basis, enter the rate in Kbps in the Average

Data Rate field. You can enter a value between 0 and 60,000 Kbps (inclusive). A value of 0 imposes no

bandwidth restriction on the QoS role.

Step 7 To define the peak data rate for TCP traffic on a per user basis, enter the rate in Kbps in the Burst Data

Rate field. You can enter a value between 0 and 60,000 Kbps (inclusive). A value of 0 imposes no

bandwidth restriction on the QoS role.

Note The Burst Data Rate should be greater than or equal to the Average Data Rate. Otherwise, the

QoS policy may block traffic to and from the wireless client.

Step 8 To define the average real-time rate for UDP traffic on a per user basis, enter the rate in Kbps in the

Average Real-Time Rate field. You can enter a value between 0 and 60,000 Kbps (inclusive). A value of

0 imposes no bandwidth restriction on the QoS role.

Step 9 To define the peak real-time rate for UDP traffic on a per user basis, enter the rate in Kbps in the Burst

Real-Time Rate field. You can enter a value between 0 and 60,000 Kbps (inclusive). A value of 0 imposes

no bandwidth restriction on the QoS role.

Note The Burst Real-Time Rate should be greater than or equal to the Average Real-Time Rate.

Otherwise, the QoS policy may block traffic to and from the wireless client.

Step 10 Click Apply to commit your changes.

Step 11 Click Save Configuration to save your changes.

Step 12 To apply a QoS role to a guest user, follow the steps in the “Using the GUI to Configure Local Network

Users” section on page 5-16.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 635 636

Commentaires sur ces manuels

Pas de commentaire

Cisco Cisco Access Registrar 4.2 Spécifications Page 144

Commentaires sur ces manuels