Cisco Router IOS XR Manuel d'utilisateur télécharger pdf (Page 65)

Cisco IOS XR Training Page 65

Gateway of last resort is not set

L 1.1.1.1/32 is directly connected, 02:26:47, Loopback0

i L2 2.2.2.2/32 [115/20] via 150.1.12.2, 00:13:05, GigabitEthernet0/3/0/2

L 100.100.100.100/32 is directly connected, 00:11:53, Loopback100

C 150.1.12.0/24 is directly connected, 02:27:12, GigabitEthernet0/3/0/2

L 150.1.12.1/32 is directly connected, 02:26:47, GigabitEthernet0/3/0/2

RP/0/7/CPU0:R1#

Hmm, no route – why is that? Is the neighbor up?

Lets check:

RP/0/7/CPU0:R1#sh ip /jointfilesconvert/356165/bgp summ

Thu Mar 29 23:25:12.041 UTC

BGP router identifier 1.1.1.1, local AS number 1

BGP generic scan interval 60 secs

BGP table state: Active

Table ID: 0xe0000000 RD version: 7

BGP main routing table version 7

BGP scan interval 60 secs

BGP is operating in STANDALONE mode.

Process RcvTblVer bRIB/RIB LabelVer ImportVer SendTblVer StandbyVer

Speaker 7 7 7 7 7 7

Some configured eBGP neighbors (under default or non-default vrfs)

do not have both inbound and outbound policies configured for IPv4 Unicast

address family. These neighbors will default to sending and/or

receiving no routes and are marked with '!' in the output below.

Use the 'show /jointfilesconvert/356165/bgp neighbor <nbr_address>' command for details.

Neighbor Spk AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down St/PfxRcd

2.2.2.2 0 2 7 6 7 0 0 00:03:09 0!

RP/0/7/CPU0:R1#

Yup, we are up for over 3 minutes now – but wait, we have an ! mark there –

no routes received.

It says to use the show /jointfilesconvert/356165/bgp neighbors address for details. Let’s see what

that says.

RP/0/7/CPU0:R1#sh /jointfilesconvert/356165/bgp neighbors 2.2.2.2

Thu Mar 29 23:26:12.572 UTC

BGP neighbor is 2.2.2.2

Remote AS 2, local AS 1, external link

Remote router ID 2.2.2.2

BGP state = Established, up for 00:04:10

Last read 00:00:05, Last read before reset 00:00:00

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 104 105

Pas de commentaire

Cisco Router IOS XR Manuel d'utilisateur Page 65