Cisco PIX 525 Spécifications télécharger pdf (Page 127)

3-15

Cisco PIX Firewall and VPN Configuration Guide

78-15033-01

Chapter 3 Controlling Network Access and Use

Access Control Configuration Example

The following procedure shows the basic configuration required for this example. This procedure is

similar to the configuration shown in “

Basic Configuration Examples:” in Chapter 2, “Establishing

Connectivity”:

Step 1 Identify the security level and names of each interface by entering the following commands:

nameif ethernet0 outside security0

nameif ethernet1 inside security100

Step 2 Identify the line speed of each interface by entering the following commands:

interface ethernet0 100basetx

interface ethernet1 100basetx

You may get better performance by changing the default auto option in the interface command to the

specific line speed for the interface card.

Step 3 Identify the IP addresses for each interface:

ip address inside 10.1.1.1 255.255.255.0

ip address outside 209.165.201.1 255.255.255.224

Step 4 Specify the host name for the PIX Firewall:

hostname pixfirewall

This name appears in the command-line prompt.

Step 5 Let inside IP addresses be recognized on the outside network and let inside users start outbound

connections:

nat (inside) 1 0.0.0.0 0.0.0.0

nat (inside) 2 192.168.3.0 255.255.255.0

global (outside) 1 209.165.201.6-209.165.201.8 netmask 255.255.255.224

global (outside) 1 209.165.201.10 netmask 255.255.255.224

global (outside) 2 209.165.200.225-209.165.200.254 netmask 255.255.255.224

Step 6 Set the outside default route to the router attached to the Internet:

route outside 0 0 209.165.201.4 1

Example 3-2 shows the basic configuration required to implement a PIX Firewall with two interfaces

with NAT.

Example 3-2 Two Interfaces with NAT—Basic Configuration