Cisco PA-E3 Spécifications télécharger pdf (Page 32)

Installing a Port Adapter

PA-E3 Serial Port Adapter Installation and Configuration

4-6

Figure 4-5 Port Adapter Installed in a Port Adapter Slot—Partial Port Adapter View

Step 5 Replace the screw in the rear of the port adapter slot. (See Figure 4-2 for its location.) Do

not overtighten this screw.

Step 6 To reinstall the Catalyst RSM/VIP2 in the system, follow the steps in the Route Switch

Module Catalyst VIP2-15 and VIP2-40 Installation and Conﬁguration Note (Document

Number 78-4780-01), which shipped with your Catalyst RSM/VIP2.

Step 7 If the interface cables have been disconnected, reconnect the interface cables to the port

adapters.

This completes the procedure for installing a port adapter on a Catalyst RSM/VIP2. Proceed to

Chapter 8, “Conﬁguring the PA-E3 Interfaces,” for information on how to conﬁgure your port

adapter interfaces.

H3152

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 67 68

Pas de commentaire

Cisco PA-E3 Spécifications Page 32