Cisco NM-16ESW - EtherSwitch Switch Manuel d'utilisateur Page 81

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 90
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 80
Configuring the Cisco Gigabit EtherSwitch EHWIC
Configuration Examples for Gigabit EtherSwitch EHWICs
81
Configuring the Cisco Gigabit EtherSwitch EHWIC
OL-23155-01
Router#
The following example shows how to configure the switch as VTP transparent:
Router#configure terminal
Router(config)#vtp transparent
Setting device to VTP TRANSPARENT mode.
Router(config)#exit
APPLY completed.
Exiting....
Router#
Spanning Tree: Examples
Spanning-Tree Interface and Spanning-Tree Port Priority: Example, page 81
Spanning-Tree Port Cost: Example, page 82
Bridge Priority of a VLAN: Example, page 82
Hello Time: Example, page 82
Forward-Delay Time for a VLAN: Example, page 83
Maximum Aging Time for a VLAN: Example, page 83
Spanning Tree: Examples, page 83
Spanning Tree Root: Example, page 83
Spanning-Tree Interface and Spanning-Tree Port Priority: Example
The following example shows the VLAN port priority of an interface being configured:
Router#configure terminal
Router(config)#interface gigabitethernet 0/1/2
Router(config-if)#spanning-tree vlan 1 port-priority 64
Router(config-if)#end
Router#
The following example shows how to verify the configuration of VLAN 1 on the interface when it is
configured as a trunk port:
Router#show spanning-tree vlan 1
VLAN1 is executing the ieee compatible Spanning Tree protocol
Bridge Identifier has priority 32768, address 0025.451b.b22a
Configured hello time 2, max age 20, forward delay 15
Current root has priority 32768, address 0008.e36d.9f70
Root port is 18 (GigabitEthernet0/1/4), cost of root path is 38
Topology change flag not set, detected flag not set
Number of topology changes 18 last change occurred 22:36:19 ago
from GigabitEthernet0/1/2
Times: hold 1, topology change 35, notification 2
hello 2, max age 20, forward delay 15
Timers: hello 0, topology change 0, notification 0, aging 300
Port 18 (GigabitEthernet0/1/2) of VLAN1 is forwarding
Port path cost 19, Port priority 128, Port Identifier 128.18.
Designated root has priority 32768, address 0008.e36d.9f70
Designated bridge has priority 32768, address 0022.bdc5.2233
Designated port id is 128.35, designated path cost 19
Vue de la page 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 89 90

Commentaires sur ces manuels

Pas de commentaire