Cisco NM-16ESW - EtherSwitch Switch Manuel d'utilisateur télécharger pdf (Page 42)

Configuring the Cisco Gigabit EtherSwitch EHWIC

How to Configure Gigabit EtherSwitch EHWICs

Configuring the Cisco Gigabit EtherSwitch EHWIC

OL-23155-01

Use the show power inline actual command to show the actual power used by the device at that time.

Router#show power inline actual

Interface Power

-------------------- -----

Gi1/0 no

Gi0/1/3 yes ( 3.599 Watts)

Gi0/1/2 yes ( 5.758 Watts)

Gi0/1/1 no

Gi0/1/0 no

Gi0/3/7 no

Gi0/3/6 yes ( 6.838 Watts)

Gi0/3/5 no

Gi0/3/4 no

Gi0/3/3 no

Gi0/3/2 no

Gi0/3/1 no

Gi0/3/0 no

Ethernet Switch Network Modules with PoE support should be reloaded to function

properly upon PoE Power Supply OIR insertion/removal.

Configuring IP Multicast Layer 3 Switching

These sections describe how to configure IP multicast Layer 3 switching:

• Enabling IP Multicast Routing Globally, page 42

• Enabling IP Protocol-Independent Multicast (PIM) on Layer 3 Interfaces, page 43

• Verifying IP Multicast Layer 3 Switching Summary, page 43

• Verifying the IP Multicast Routing Table, page 45

Enabling IP Multicast Routing Globally

You must enable IP multicast routing globally before you can enable IP multicast Layer 3 switching on

Layer 3 interfaces.

For complete information and procedures, see these publications:

• Cisco IOS IP Multicast Configuration Guide, Release 15.1

http://www.cisco.com/en/US/docs/ios/ipmulti/configuration/guide/15_1/imc_15_1_book.html

• Cisco IOS IP Addressing Services Command Reference

http://www.cisco.com/en/US/docs/ios/ipaddr/command/reference/iad_book.html

• Cisco IOS IP Multicast Command Reference

http://www.cisco.com/en/US/docs/ios/ipmulti/command/reference/imc_book.html

To enable IP multicast routing globally, use the ip multicast-routing command in global configuration

mode.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 89 90

Pas de commentaire

Cisco NM-16ESW - EtherSwitch Switch Manuel d'utilisateur Page 42