Cisco CX-FEIP-1TX= Installation and con?guration Manuel d'instructions télécharger pdf (Page 101)

100

101

Software Procedures

9. Click Next to select the NT Direct Connection.

10. Select COM 1 or COM 2, and then click Next.

11. Click Finish.

12. In the Modem Properties window, select NT Direct Connection,

then click Properties.

13. Set the following parameters:

- Maximum speed: 38 400

- Check: Only connect at this speed

- Data bits: 8

- Parity: None

- Stop bits: 1

- Mode: Auto Answer

In Advanced Settings window, do the following for a direct connect

cable:

- Turn off: Error control

- Turn off: Flow Control

14. Click OK and close the Control Panel window.

Physically Connecting the PC to an NSU

• Connect an RS-232 straight DTE serial cable between the NSU’s serial

port and the PC’s serial port.

Creating a Dial-Up Network Connection on Windows 95/98

Typically, you need to follow this procedure twice to create two Dial-up

Networking connections, one for on-site direct access, and one for remote

modem access.

1. On the Start menu, point to Programs, point to Accessories, and

then click Dial-Up Connections.

2. Double-click Make New Connection.

3. Enter an appropriate name for the connection (for example, Direct for

direct connections, Remote or a customer’s name for remote

connections) and click Next.

Tip: If you are connecting through a modem, use a null modem adapter on

the NSU side.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 403 404

Commentaires sur ces manuels

Pas de commentaire

Cisco CX-FEIP-1TX= Installation and con?guration Manuel d'instructions Page 101

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cisco CX-FEIP-1TX= Installation and con?guration