Cisco Blower Module 10000 ESR Guide d'installation télécharger pdf (Page 102)

10-4

Cisco 10000 Series Routers Line Card Hardware Installation Guide

OL-6773-04

Chapter 10 1-Port Gigabit Ethernet Half-Height Line Card Overview

LEDs

The 1-port Gigabit Ethernet half-height line card LEDs are listed in Figure 10-1.

Figure 10-1 1-Port Gigabit Ethernet Half-Height Line Card Faceplate Description

Table 10-3 provides a description of the 1-port Gigabit Ethernet half-height line card LEDs.

1 Ejector levers 4 SFP module port (TX/RX)

2 FAIL LED 6 LINK LED

3 RX (receive) LED 7 TX (transmit) LED

CISCO

10000

FAIL

LINK

GIGABIT ETHERNET

76294

Table 10-3 LED Description

LED Label Color State Meaning

FAIL Yellow Off Off when line card is working properly. Turns on for

a few seconds during line card power-on self test

(POST), then turns off.

Blinking The FAIL LED blinks during the following SFP

module faults:

• An SFP module other than a Cisco brand is

inserted.

• A non-Gigabit Ethernet SFP module is inserted.

• A hardware problem occurs in a valid SFP

module.

On The FAIL LED may blink in different patterns for certain

POST failures (slot ID parity error and BPE loopback

test failure).

If the line card POST fails.

If any failure occurs.

RX (receive) Green On The port is receiving traffic.

Off The port is not receiving traffic.

TX (transmit) Green On The port is transmitting traffic.

Off The port is not transmitting traffic.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 253 254

Pas de commentaire

Cisco Blower Module 10000 ESR Guide d'installation Page 102