Cisco 1005 - 1005 Router Guide de l'utilisateur télécharger pdf (Page 14)

2-14 Cisco 1005 User Guide

Connecting to the Network and Powering Up the Router

To connect the network interface cables to the router, perform the following steps:

Step 1 Connect an Ethernet cable (not provided) to the 10BaseT port. (See Figure 2-8.)

Use a straight-through Ethernet cable if you are connecting the router to a

10BaseT hub. Use a crossover Ethernet cable if you are connecting the router to a

PC network interface card.

Warning The ports labeled “10BaseT,” “Console,” and “PCMCIA” are safety extra-low

voltage (SELV) circuits. SELV circuits should only be connected to other SELV circuits.

(To see translated versions of this warning, see the appendix “Translated Safety

Warnings.”)

Figure 2-8 Connecting to the 10BaseT Port

12VDC

Ethernet cable

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Pas de commentaire

Cisco 1005 - 1005 Router Guide de l'utilisateur Page 14