Cisco Physical Access Gateway Manuel d'utilisateur télécharger pdf (Page 29)

Cisco ConfidentialPresentation_ID

The Gateway Module

 The second device to configure and install is the gateway module.

 Powered via POE, or 12 to 24 VDC

 It requires IP address (static or DHCP), the CPAM server IP

address, and the TCP port number to use when communicating

with the CPAM server.

 Software image is pushed to the gateway module from the CPAM

server or directly from the gateway web interface..

 External device attachment to the gateway can be done before, or

after the configuration is completed.

 Additional module attachment is made via the 3 wire CAN bus,

and are powered via 12 to 24 VDC only. No POE for the add on

modules.

 Configuration is loaded to the gateway and the downstream

modules via the CAN bus from the gateway module. No user

action needed to push configuration to the downstream modules.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 113 114

Pas de commentaire

Cisco Physical Access Gateway Manuel d'utilisateur Page 29