Cisco OL-4015-08 Guide de dépannage télécharger pdf (Page 100)

3-6

Cisco Broadband Local Integrated Services Solution Troubleshooting Guide

OL-5169-01

Chapter 3 Trouble Isolation Procedures

Finding System Information

• If type=event-level, then value designates the severity of the events or alarms to include in the

log files, which can be

CRITICAL, MAJOR, MINOR, WAR N , or INFO.

All events or alarms whose severity is equal to or greater than the event level specified are included

in the designated event or alarm log file.

Tip Cisco recommends that you store events of all severity levels in the event and alarm log files by entering

INFO as the value in this command. This permits the operator to access all event and alarm reports.

Changing Threshold and Throttle Values

The threshold and throttle values used in event and alarm reporting are user-provisionable. You can use

the following show event-prov command to display the current threshold and throttle values for any

event or alarm message:

show event-prov type=callp; number=9;

Reply : Success: Entry 1 of 1 returned.

REPORTTYPE=2

REPORTNUMBER=9

REPORTDESCRIPTION=No Route Available for Carrier Dialed

THRESHLIM=100

THROTTLELIM=20

DW1NAME=Orig Type(Trunk or S

DW2NAME=Orig Sub or TG id

DW3NAME=Calling Party Number

DW4NAME=Called Party Number

DW5NAME=Carrier Code Dialed

DW6NAME=n/a

DW7NAME=n/a

DW8NAME=n/a

CAUSE1=No route is available for the interexchange carrier (IXC) dialed.

ACTION1=The data words in the event report indicate the parameters that need to

be corrected. Refer to office records for the carrier.

CAUSE2=Parameter(s) in the carrier and/or route-grp table are missing or

incorrect for the carrier.

ACTION2=Determine whether the routing parameters were entered correctly in the

carrier and/or route-grp tables.

ACTION3=If the carrier-id or route-grp-id are not specified, or are incorrect in

the dial-plan table, enter the correct values. Use the change carrier or change

route-grp command.

The command show event-prov with no parameters displays all events that are provisioned.

The command show event-prov with only

type specified displays all events of that type.

Use the following change event-prov command to specify event threshold and throttle values:

change event-prov type=<type>; number=<n>; threshold=<n>; throttle=<n>;

•

threshold—The maximum number of reports of the designated event or alarm that can be issued in

any 30-minute interval. Valid values are 1 to 100.

• throttle—The number of occurrences of the designated event or alarm message required to trigger

the issuance of one report. Valid values are 1 to 100.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 369 370

Commentaires sur ces manuels

Pas de commentaire

Cisco OL-4015-08 Guide de dépannage Page 100

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cisco OL-4015-08