Cisco NAS200 Guide de l'utilisateur télécharger pdf (Page 8)

Chapter 2

Configuration Using the Setup Wizard

Network Storage System with 2 Bays

For the public folder, keep the default drive letter, or 2.

select a different letter from the drop-down menu.

Click Next.

Map Network Drive

To install the Linksys Network Drive Mapping Utility on 3.

your computer, click Yes.

Install Drive Mapping Utility

T4. he Setup Wizard automatically installs the utility.

Click OK.

Drive Mapping Utility Installed

The network drive(s) are mapped to your computer. 5.

Click Exit to exit the Setup Wizard, or click Next to

return to the Welcome screen.

Network Drive Mapped

The computer has been configured.

Set up Second Drive

NOTE: Make sure your second hard drive

is a 3.5-inch, Serial-ATA (SATA) hard drive.

If you plan to stripe (RAID 0) or mirror

(RAID 1) your drives, then match the drive sizes

for maximum drive use.

WARNING: Low-profile or half-height hard

drives can be used at your own risk; however,

Linksys does not support the use of these drives

as they are not securely held in place inside the

Network Storage System.

Follow the instructions to add a second hard drive to

your previously configured Network Storage System. If

you physically install a second drive without running the

Setup Wizard, then the second drive will not be formatted.

It will have to be manually formatted using the web-based

utility (refer to “Chapter 3: Advanced Configuration”).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 55 56

Pas de commentaire

Cisco NAS200 Guide de l'utilisateur Page 8