Cisco NAS200 Guide de l'utilisateur télécharger pdf (Page 6)

Chapter 1

Product Overview

Network Storage System with 2 Bays

USB 2 The USB 2 port connects to your second

USB storage device. Press the USB 2 button

to eject the device from the USB 2 port. After

the Network Storage System beeps once and

the USB 2 LED powers off, you can remove the

device.

RESET The RESET button has two functions:

To reset the network settings, such as •

the IP address, of the Network Storage

System, press and hold this button for

two seconds. The Network Storage

System resets to DHCP and tries to

get an IP address from the DHCP

server on your network. If there is no

DHCP server on your network, the

Network Storage System will be set to

its default IP address, 169.254.xx.xx

(the x’s represent randomly generated

numbers). The Network Storage System

beeps once to indicate that the reset

has occurred.

To reset the password of the Network •

Storage System to its default value

of admin, press and hold this button

for 10 seconds. The Network Storage

System beeps twice to indicate that the

reset has occurred.

Drive Bay Doors

The drive bay door covers the opening of the drive bay,

which holds the hard drive. Push together the clips to

remove the drive bay door. Disk 1 is inserted into the

upper bay, and Disk 2 is inserted into the lower bay.

Notification Sounds

The Network Storage System emits sounds to indicate

different activities or status information.

Notification Sounds

Sound Meaning

1 beep

Power or Reset button pushed

USB device ready to be removed

2 beeps

Reset button pushed and held for over

10 seconds

3 beeps every

15 seconds for 3

minutes

Available disk capacity is less than 2%

of total capacity or the number you set

through the web-based utility (2 or 5 GB)

1 2 3 4 5 6 7 8 9 10 11 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Cisco NAS200 Guide de l'utilisateur Page 6

Commentaires sur ces manuels