Cisco Aironet 340 Series Guide d'installation télécharger pdf (Page 47)

4-5

Cisco Aironet Access Point Hardware Installation Guide

OL-0738-02

Chapter 4 Troubleshooting

Resetting to the Default Configuration

Step 10 After the access point reboots and the Express Setup screen appears, reconfigure the access point by

using the terminal emulator or an Internet browser.

Steps for Firmware Versions 11.06 or Earlier

Follow the steps in this section if your access point is running firmware version 11.06 or earlier.

Note The following steps reset all configuration settings to factory defaults, including passwords, WEP keys,

the IP address, and the SSID. If you do not need to reset the entire configuration, use the Configuration

Reset buttons on the System Configuration Setup page in the web-browser interface. Consult the Cisco

Aironet Access Point Software Configuration Guide for more information on the reset buttons in the

web-browser interface.

Determining the Boot-Block Version

The steps you follow to reconfigure the access point depend on the version of the access point’s boot

block. Follow these steps to find out which boot block version is on your access point:

Step 1 Open a Telnet session to the access point.

Note You can also use these instructions while communicating with the access point through the

console port or with an SNMP manager. Skip to Step 3 if you use an SNMP manager.

Step 2 Type :cmd and press Enter to switch from text-browser mode to SNMP mode.

Step 3 Type bootblockVersion and press Enter. Text appears with information about the system. If your access

point’s boot block version is 1.01, the text might look like this:

OID: iso.org.dod.internet.private.enterprises.aironet.awcVx.awcSystem.

bootblockVersion

Value [RO]: 1.01

Step 4 Type exit and press Enter to return to text-browser mode.

Step 5 If your boot block version is 1.01 or earlier, follow the instructions in the “Reconfiguration Steps for

Boot Block Version 1.01 or Earlier” section on page 4-6. If your boot block version is 1.02 or later,

follow the instructions in the “Reconfiguration Steps for Boot Block Version 1.02 or Later” section on

page 4-7.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 69 70

Pas de commentaire

Cisco Aironet 340 Series Guide d'installation Page 47