Cisco UCS E-Series Guide d'installation télécharger pdf (Page 29)

Hardware Installation Guide for Cisco UCS E-Series Servers

Installing E-Series Servers in Cisco ISR G2 Routers

Cisco UCS E-Series Server Modules Hardware Installation Guide

Figure 16 Replacing the PCIe Assembly

Step 4

Remove the screw holding the flex assembly in place

Step 5 Remove the two screws connecting the plastic bracket to the motherboard.

Step 6 Disconnect the flex assembly connector from the motherboard.

Step 7 Remove the PCIe assembly.

Step 8 Slide the plastic bracket off the end of the PCIe card and save the bracket for future use.

Installing the PCIe Assembly

Follow these steps to install the PCIe Assembly:

Step 1 Connect the wrist strap clip to an unpainted portion of the chassis frame to channel unwanted ESD

voltages to ground.

Step 2 Turn off power to the router.

The Cisco 3900 series routers support OIR. (See the “Online Insertion and Removal on a Cisco ISR G2

Router” section on page 22)

Step 3 Connect the flex assembly onto the PCIe connector on the PCIe Card. See Figure 16.

1 Captive Screws on the Face Plate 2 Flex Assembly Screw

3 Plastic Bracket screw 4 PCIe Assembly

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Cisco UCS E-Series Guide d'installation Page 29