Cisco UCS E-Series Guide d'installation télécharger pdf (Page 19)

Hardware Installation Guide for Cisco UCS E-Series Servers

Installing E-Series Servers in Cisco ISR G2 Routers

Cisco UCS E-Series Server Modules Hardware Installation Guide

Installing Slot Dividers

Slot dividers (see Figure 7) are used to customize service module slots for the different form factors

(Single-wide and Double-wide). Slot dividers are used on the following Cisco ISR G2 routers:

• Cisco 2911, 2921, and 2951

• Cisco 3900 series

Figure 7 Slot Divider for Service Module Slots (shown without retention screw)

To install a slot divider, perform the following steps:

Step 1 Remove any installed service modules, blank faceplates, and slot adapters from the router slot you plan

to use.

Step 2 Insert the top rails of the slot divider between the two guide rails in the top of the module slot. (See

Figure 8)

Figure 8 Inserting a Slot Divider into a Service Module Slot (with retention screw)

Step 3 Push the slot divider in until it is fully seated. Service module dividers have a long retention screw that

slides into the divider. (See Figure 8)

Step 4 Tighten the retention screw on the front of the slot divider with a number 1 Phillips screwdriver. (See

Figure 9) When the slot divider is fully inserted, its front surface is flush with the panel of the router.

(See Figure 9)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Pas de commentaire

Cisco UCS E-Series Guide d'installation Page 19