Cisco UCS B22 M3 Guide de dépannage télécharger pdf (Page 21)

Send document comments to ucs-docfeedbac[email protected]

Cisco UCS B22 Blade Server Installation and Service Note

OL-27513 -01

Removing a Blade Server Cover

Installing a CPU and Heat Sink

Before installing a new CPU in a server, verify the following:

• The CPU is supported for that model server.

• A BIOS is available and installed that supports the CPU/DIMM and server combination.

• The service profile for this server in UCS Manager will recognize and allow the new CPU. This is

especially important if you have been using a single processor and install a second processor.

To install a CPU and heat sink, follow these steps:

Step 1 Prime the alignment tool (UCS-CPU-EN-PNP=) by pressing the central button.

Step 2 Remove the new CPU from the packaging, and place it into the alignment tool as shown in Figure 12 .

Only touch the CPU by the edges.

Figure 12 Loading the Alignment Tool

331371

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Pas de commentaire

Cisco UCS B22 M3 Guide de dépannage Page 21