Cisco UCS B22 M3 Guide de dépannage télécharger pdf (Page 10)

Send document comments to ucs-docfeedbac[email protected]

Cisco UCS B22 Blade Server Installation and Service Note

OL-27513 -01

Installing and Removing a Blade Server Hard Drive

Table 2 shows the drives supported in this blade server.

Removing a Blade Server Hard Drive

To remove a hard drive from a blade server, follow these steps:

Step 1 Push the button to release the ejector, and then pull the hard drive from its slot.

Figure 3 Removing the Hard Drive

Step 2

Place the hard drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in

another blade server.

Step 3 Install a blank faceplate (UCS-HD-BBLKD) to keep dust out of the blade server if the slot will remain

empty.

Table 2 Supported Hard Disk Drives (HDD)

Product ID Description

HDDs

A03-D146GC2 146 GB 6 Gb SAS transfer rate, 15 K RPM SFF HDD/hot plug/drive sled mounted

UCS-HDD300GI2F105 300 GB 6 Gb SAS transfer rate, 15 K RPM SFF HDD/hot plug/drive sled mounted

A03-D300GA2 300 GB 6 Gb SAS transfer rate, 10K RPM SFF HDD/hot plug/drive sled mounted

A03-D600GA2 600 GB 6 Gb SAS transfer rate, 10 K RPM SFF HDD/hot plug/drive sled mounted

SSDs

UCS-SD100G0KA2-E 100 GB Std Height 15 mm SATA SSD hot plug/drive sled mounted

331362

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Pas de commentaire

Cisco UCS B22 M3 Guide de dépannage Page 10