Cisco AS5200 - Universal Access Server Manuel d'utilisateur télécharger pdf (Page 8)

6

2 Install the Universal Access Server (continued)

Connect the Dual T1/PRI Card

for WAN Access

You can connect the access server to a dual T1 or

E1/PRI card for WAN access. If you have a dual

E1/PRI card, go to the next section, “Connect the

Dual E1/PRI Card for WAN Access.”

You will need two straight-through

RJ-48C-to-RJ-48C cables to connect the dual

T1/PRI card to a WAN.

Note: RJ-48C-to-RJ-48C cables are not included.

Step 1 Connect one end of the straight-through

RJ-48C-to-RJ-48C cable to the port

labeled Port 0 on the rear panel of the

access server.

Step 2 Connect the other end of the cable to an

RJ-48C jack.

Step 3 Repeats steps 1 and 2 to connect a second

cable to the port labeled Port 1.

RJ-48C jack

Straight-through

RJ-48C-to-RJ-48C cable

T1/PRI

port 0 (RJ-45)

H10337

Universal access server

T1/PRI card

T1/PRI

port 1 (RJ-45)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire