Cisco PSUS4 Guide de l'utilisateur télécharger pdf (Page 34)

PrintServer for USB with 4-Port Switch

Chapter 8: Bi-Admin Management

Overview

Chapter 8: Bi-Admin Management

Overview

The PrintServer is managed by a utility program called Bi-Admin on the PrintServer’s Setup CD. Fully compatible

with Windows 98, Me, 2000, and XP, Bi-Admin allows you to change the PrintServer’s internal settings, check on

the unit’s status, and perform basic diagnostic tests. Note that the Bi-Admin program must be installed only on

the network administrator’s computer. First, you will install Bi-Admin on your computer. Then, you will be able to

use the management utility.

Bi-Admin Installation

1. If you haven’t already done so, insert the Setup CD-ROM into the computer’s CD-ROM drive. The Setup CD-

ROM should run automatically. If it does not, click the Start button and choose Run. In the box that appears,

enter D:\setupWizard.exe (if “D” is the letter of your CD-ROM drive).

2. When you see Figure 8-1, click Bi-Admin Install to continue. Click Exit to end the installation.

3. The Welcome screen of the Bi-Admin Setup program, Figure 8-2, will appear first. You will need to close any

other programs you have open before you continue. Click Cancel to quit the setup program, then close the

open programs. Click Next to continue with the Bi-Admin installation.

Figure 8-2: Bi-Admin Setup Welcome

Figure 8-1: Welcome

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 57 58

Pas de commentaire

Cisco PSUS4 Guide de l'utilisateur Page 34