Cisco WET54G Guide de l'utilisateur télécharger pdf (Page 19)

Chapter 5: Setting Up the Wireless-G Ethernet Bridge

Wireless-G Ethernet Bridge

10. Review your settings on the Confirmation screen, shown in Figure 5-10. Write down the Bridge’s IP Address if

you want to configure advanced settings through the Bridge’s Web-based Utility. Click the Yes button to save

these settings. Click the No button to exit the Setup Wizard.

11. The next screen, shown in Figure 5-11, shows that the configuration is complete. To configure any other

Wireless-G Ethernet Bridges on your network, run this Setup Wizard again. To register the Bridge, click the

Online Registration button. To exit the Setup Wizard, click the Exit button.

The Wireless-G Ethernet Bridge is now successfully configured for your network.

For advanced configuration, proceed to “Chapter 7: Using the Wireless-G Ethernet Bridge Web-based

Utility.” Otherwise, go to “Chapter 6: Connecting the Wireless-G Ethernet Bridge for Network Use.”

Figure 5-10: Confirmation

Figure 5-11: Congratulations

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 53 54

Pas de commentaire

Cisco WET54G Guide de l'utilisateur Page 19