Cisco WET54G Guide de l'utilisateur télécharger pdf (Page 14)

Chapter 4: Connecting the Wireless-G Ethernet Bridge for Setup

Wireless-G Ethernet Bridge

Chapter 4: Connecting the Wireless-G Ethernet Bridge for

Setup

1. Attach the Bridge’s antenna.

2. Plug the included Ethernet network cable into the LAN port on the back panel of the Bridge, shown in Figure

4-1.

3. Plug the other end of the Ethernet network cable into the RJ-45 port of the hub, switch, or PC you wish to use

to configure the Bridge.

4. Plug the supplied power cable into the Power port on the back panel of the Bridge, shown in Figure 4-2. Then

plug the other end into an electrical outlet.

Proceed to “Chapter 5: Setting Up the Wireless-G Ethernet Bridge.”

Figure 4-1: Connect to the Network

Figure 4-2: Connect the Power

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 53 54

Pas de commentaire

Cisco WET54G Guide de l'utilisateur Page 14