Cisco SPA3102 Manuel d'utilisateur télécharger pdf (Page 2)

Section 1 – Getting Started

When you receive your SPA-3102 it should contains the following items:

1. SPA-3102

2. Power supply

3. Network Cable

Setting up the hardware:

Step 1: Connect the power cable to your SPA-3102

Step 2: Connect the network cable from your SPA-3102 to your DHCP enabled modem/router OR

Connect the network cable from your modem to the SPA-3102 WAN port and connect your

PC via Ethernet cable to the LAN port of the SPA-3102.

Step 3: Connect an analogue phone to the “Phone” port in the SPA-3102.

Step 4: Turn the power on

Step 5: Pick up the phone and dial **** (You should hear a voice saying Linksys Configuration Menu)

Step 6: Dial 110# (Write down the IP address that is returned)

Step 8: Dial 7932#, then dial 1# to enable the web server, then press 1 to save..

Step 9 :Hang up

Step 10: Connect your PSTN line to the “Line” port of the SPA-3102.

At this stage, you can choose whether to upgrade the firmware. The latest version of the

SPA-3102 firmware at the time of writing this document is 3.2.10(GW).

To upgrade the firmware see Appendix D.

1 2 3 4 5 6 7 ... 23 24

Pas de commentaire

Cisco SPA3102 Manuel d'utilisateur Page 2