Cisco SCE 1000 2xGBE Guide de l'utilisateur télécharger pdf (Page 325)

100

101

Appendix A

GigaBitEthernet Interface Configuration Mode Commands

SCE 1000 2xGBE Release 2.0.10 User Guide

OL-7117-02 A-55

GigaBitEthernet Interface Configuration Mode Commands

[no|default] auto-negotiate

Configures the GigaBitEthernet Interface auto-negotiation mode. Use this command to either

enable or disable auto-negotiation. When set to no auto-negotiation, auto-negotiation is

always disabled, regardless of the connection mode.

Default On for active connection mode; Off for passive connection mode

Authorization admin

Mode GigaBitEthernet Interface Configuration

SAGE GUIDELINES

• Note that auto-negotiation does not work when the SE2000 is connected via optical splitter.

XAMPLE:

The following example configures the SE2000 to perform no auto-negotiation.

SCE 1000(config if)#no auto-negotiate

SCE 1000(config if)#

bandwidth bandwidth burst-size burstsize

Sets Gigabit Ethernet shaping.

Default Bandwidth=100000K (100 Mega bps), burst-size=5000 (5 K bytes)

Authorization admin

Mode GigabitEthernet Interface Configuration

ARAMETERS

bandwidth GigabitEthernet bandwidth measured in kbps.

burstsize Burst size in bytes.

SAGE GUIDELINES

• This command is valid for the line interfaces only, Interface GigabitEthernet

0/#.

XAMPLE:

The following sets bandwidth and burst size.

SCE 1000(config-if)#bandwidth 100000 burstsize 5000

SCE 1000(config-if)#

1 2 ... 320 321 322 323 324 325 326 327 328 329 330 ... 489 490

Commentaires sur ces manuels

Pas de commentaire

Cisco SCE 1000 2xGBE Guide de l'utilisateur Page 325

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cisco SCE 1000 2xGBE