Cisco IPS 7.1 Guide d'installation télécharger pdf (Page 172)

6-8

Cisco Intrusion Prevention System Appliance Hardware Installation Guide for IPS 7.1

OL-24002-01

Chapter 6 Installing and Removing the ASA 5500 AIP SSM

Installation and Removal Instructions

Step 5 Locate the grounding strap from the accessory kit and fasten it to your wrist so that it contacts your bare

skin. Attach the other end to the chassis.

Step 6 Remove the two screws at the left back end of the chassis.

Step 7 Remove the ASA 5500 AIP SSM and set it aside.

Note If you are not replacing the ASA 5500 AIP SSM immediately, install the blank slot cover. Slot

covers must cover all empty slots. This prevents EMI from disrupting other equipment.

Step 8 If you need to replace the existing the ASA 5500 AIP SSM, insert the new ASA 5500 AIP SSM through

the slot opening.

Note Do not replace the ASA 5500 AIP SSM with a different model. The the adaptive security

appliance will not recognize it.

Step 9 Attach the screws to secure the ASA 5500 AIP SSM to the chassis.

Step 10 Power on the adaptive security appliance.

Step 11 Reset the ASA 5500 AIP SSM.

asa# hw-module module 1 reset

Reset module in slot 1? [confirm]

Step 12 Press Enter to confirm.

Step 13 Check the indicators to see if the ASA 5500 AIP SSM is properly installed. If the ASA 5500 AIP SSM

is properly installed, the POWER indicator is solid green and the STATUS indicator is flashing green.

Or you can verify installation using the show module 1command.

For More Information

• For more information on ESD, see Safety Recommendations, page 2-2.

• For the procedure for verifying whether the ASA 5500 AIP SSM is properly installed, see Verifying

the Status of the ASA 5500 AIP SSM, page 6-7.

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 421 422

Pas de commentaire

Cisco IPS 7.1 Guide d'installation Page 172