Cisco Ethernet switch Instructions d'exploitation télécharger pdf (Page 96)

82 Cisco Systems Intelligent Gigabit Ethernet Switch Module

Figure 6-2 Management Module External Network Interface window

The BladeCenter Management Module defaults to the IP address 192.168.70.125. If you

have more than one BladeCenter on your Management Network, you are required to change

the external network interface (eth0). If you do not, you will have IP address conflicts that will

result in not being able to access your Management Modules. In Figure 6-2, we configured

the external interface to be on the same default management subnet with a unique IP

address.

After the external interface is configured, the internal interface needs to be configured with

another unique IP address. The purpose of internal network interface (eth1) (Figure 6-3) is to

communicate with the BladeCenter devices across an Ethernet link. Note that if you do not

configure the internal interface on the same network as the External interface, you will not

have IP connectivity from the Management Module to your switches modules.

Figure 6-3 Management Module Internal Network Interface window

Click Save at the bottom of the page. The Management Module must be restarted to

implement the changes.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 265 266

Pas de commentaire

Cisco Ethernet switch Instructions d'exploitation Page 96