Cisco Ethernet switch Instructions d'exploitation télécharger pdf (Page 109)

Chapter 6. IBM eServer BladeCenter system initial setup 95

cp -f basp.o /var/tmp/basplnx-buildroot/lib/modules/`uname -r`/kernel/net/basp

mkdir -p /var/tmp/basplnx-buildroot/lib/modules/`uname -r`/build/include/linux

cp -f nicext.h /var/tmp/basplnx-buildroot/lib/modules/`uname -r`/build/include/linux

Processing files: basplnx-6.2.1-1

Executing(%doc): /bin/sh -e /var/tmp/rpm-tmp.67022

Finding Provides: (using /usr/lib/rpm/find-provides)...

Finding Requires: (using /usr/lib/rpm/find-requires)...

PreReq: /bin/sh /bin/sh /bin/sh rpmlib(PayloadFilesHavePrefix) <= 4.0-1 rpmlib(CompressedFileNames) <= 3.0.4-1

Requires(interp): /bin/sh /bin/sh /bin/sh

Requires(rpmlib): rpmlib(PayloadFilesHavePrefix) <= 4.0-1 rpmlib(CompressedFileNames) <= 3.0.4-1

Requires(post): /bin/sh

Requires(preun): /bin/sh

Requires(postun): /bin/sh

Requires: ld-linux.so.2 libc.so.6 /bin/sh libc.so.6(GLIBC_2.0) libc.so.6(GLIBC_2.1) libc.so.6(GLIBC_2.1.3)

Wrote: /usr/src/redhat/RPMS/i386/basplnx-6.2.1-1.i386.rpm

Executing(%clean): /bin/sh -e /var/tmp/rpm-tmp.3526

[root@localhost redhat]# rpm -ivh RPMS/i386/basplnx-6.2.1-1.i386.rpm

Preparing... ########################################### [100%]

1:basplnx ########################################### [100%]

[root@localhost redhat]#

________________________________________________________________________________________________

6.2.3 Broadcom Advanced Control Suite installation

Network interface card (NIC) teaming is one method for providing high availability and fault

tolerance in IBM eServer servers. In this example, we use Broadcom Advanced Server

Program (BASP) to implement teaming functionality along with load balancing, fault

tolerance, and VLAN tagging.

To enable NIC teaming, the Broadcom Advanced Control Suite application must be used on

the HS20s. The program is included with the drivers, which you can download at:

http://www.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR-43815

To install the suite, perform the following steps:

1. Navigate to the location where the Broadcom Advanced Control Suite application files

were extracted (default C:\Drivers\BcomXXX, where XXX is the code level). Execute

Launch.exe. You will see a window similar to the one shown in Figure 6-10 on page 96.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 265 266

Pas de commentaire

Cisco Ethernet switch Instructions d'exploitation Page 109